When you see the well pump running but with no water pressure, your mind is filled with thoughts of permanently damaging the pump, scarcity of water, and so on. Before you call in an expert or go for the replacement, it is necessary that you know the possible reason behind, and you might be able to resolve the issue on your own.

After all, maintenance, or replacement both require a hefty amount. It is a common issue among households, no matter what type of pump you have installed and how deep a well is. So, are you ready to fix your well pump yourself? Let’s proceed.

Why is my well pump not building pressure?

Without water, there is no life. At all times, clean water should be readily available to you. For that, well pumps are widely used, but you need to make certain that water comes out when the pump runs.

In case you turn on the well pump, but nothing comes out, you wonder what might have gone wrong. Different scenarios can be played out, let’s go through them individually.

Power supply

Starting with the basic reason, we often forget to check the power supply, and we continue to blame the well pump for no water pressure. Remember, a well pump needs electrical power unless you have a hand pump installed. Check for the switch if it’s turned on and there is no power outage.

Power surges

At times we are faced with power disruptions, and that damages our electrical appliances, including the well pump. A power surge is different from a power failure. Power failure does not damage the appliances, but a power surge does.

Check that the pump is not heating up or there are no fumes being produced.

Pressure switch

Do you know there is a pressure switch linked with the well pump? It is what controls the water pressure, and you can regulate it accordingly. Make sure that the pressure switch setting is set to normal because there will be no water pressure even if the pump runs when you have put it on low.

Secondly, your switch might not be in working condition. As a result, it should also be verified. Replace the pressure switch if you find it not working properly.

Filtration system failure

Another reason you see no water pressure building up is due to the failure of the filtration system. It occurs because sediments and minerals form clogged and prevent the water from passing through.

You can check this by sidestepping the filtration system and seeing if water comes out with pressure. The filtration system has to be replaced if this happens.

Pump failure

When dealing with electrical or mechanical parts, remember that they are prone to failures, and the same goes with well pumps. It might happen because the well contains hard water, or there may be any other reason. The pump may still be running, but with no water pressure.

Similarly, other components may also fail or cause problems, including impellers not running properly and water lines or electrical lines that have been damaged.

Low well water level

One possible reason behind no water pressure is that the well does not have enough water to supply. Loss of water in the well is a serious issue, and you must let the well recover.

You should also make sure the pump you are using is compatible with the flow rate.

Leakage

It can be anywhere from your home to the pressure tank and inside the well. Leakages are easy to spot and easy to fix. It is simple to locate where the problem lies with a thorough inspection.

Conclusion

There is no use of a well or running a pump when there is no water pressure at the end. There is nothing to freak about if you don’t see water coming out of your faucet. You may just need a quick fix, and that’s all. Thoroughly inspect each and every element of a well pump, check water lines, and make sure the pump is not affected due to power surge, ultimately, you will find a gap, and you can get it fixed accordingly.

Now, if you ever see a well pump running but no water pressure, troubleshoot and set the problem yourself before calling in a professional.