No matter how good the electrical system you have, homeowners are mostly seen to be worried about power failure problems affecting different appliances and the light switches as well. Jumping power from one light switch to another seems to be a perfect solution. If you are the one facing the problem, get yourself ready to learn how to jump power from one light switch to another in an easy and effective way.

Typically, the light switch and the bulb are independent of each other. The switch disengages the circuit when it is off, and thus the current stops running through. While electricians and electrical contractors have to deal with these issues on a daily basis, sometimes it comes as a surprise for homeowners. Here’s what you need to know about jumping power from one light switch to another.

Jump power from one light switch to another

The info comes in handy when you have to add more lights to an area in your home. When wiring a circuit, there are many options for getting power to the load (lights, outlets, etc.) after the main power switch has been turned on. Use a circuit tester to make certain that the electrical power is off, it must be done every time you do any kind of electrical project.

Let’s now get into the steps involved with the power jump from one light switch to another.

Step 1

Open your main electrical supply, which is also referred to as a trip switch box. This is from where you control all the supplies to your home. If there comes a fault, it turns off the electrical power.

Step 2

Find the trip switch for the circuit that is linked to the switch you wish to jump. Power down the switch so that electricity is no longer flowing. You will see that each trip will be labeled accordingly, and it will help you find the right one you need.

Step 3

With a screwdriver, remove the light switch fitting from the wall and access the terminals by removing the cover.

You will see the terminals labeled with “In” or “Com”. At this stage, you have to loosen the screw with terminals labeled as “In” and insert the wire in the other terminal. Do it carefully and once you are done, tighten the screw.

Step 4

You are about to complete it all. Use a screwdriver to tighten the light-fitting cover, and it’s time to check your work. Turn on the trip and try to turn the switch back and forth between the “on” and “off” positions. You have jumped the wire, so the light should not operate. If this is what you get, you have done it all correctly.

If you have more than one light fixture that needs to be controlled from one location, you can use a switchable power supply to control them. A switchable power supply is a device that allows you to turn the power to one or more lights, outlets, or any other electrical device on or off from a single location. Power to the additional light fixtures can easily be controlled from the switchable power supply.

Be aware that the above instructions are for the single pole light switch. For more information, do check out how to wire a light switch? And single pole light switch wiring.

Conclusion

If you’re moving into a new place, or it’s time to upgrade your house, you may be wondering how to jump power from one light switch to another. It’s in reality easier than you might have thought. All you are required to do is to implement the instructions clearly. Having knowledge of electrical wires and systems is beneficial; though, it is not necessary. Make the most out of it, and do not forget to check on the safety concerns.